Description

Consists of 6 IR diodes. IR Follower module can be used to sense infrared light as a way to guide your Arduino project.

Features

• 100% Arduino Compatible

• Can be used to build a light following robot

Pin Outs Overview

The device has a digital and analog output for each IR diode. The analog output for each respective LED will put out a voltage from GND to VCC depending on the amount of light applied to the diode. The digital output for each respective LED will put out VCC (HIGH) if light is not detected, and GND (LOW) if light is detected.

Calibration

There’s a trimpot in the center of the device. This trimpot is used to adjust the digital comparators. Turning this trimpot changes the point at which light is considered detected, or not detected on the digital outputs. Turning it left will make the device more sensitive (less IR light is needed to pull the digital outputs LOW). Turning it right will make the device less sensitive (more IR light is needed to pull the digital outputs HIGH). The trimpot does not effect the analog outputs.

How to use it with the Arduino

Connect the sensor to the Arduino using either the digital or analog outputs and apply 5V.